Aeroflow Performance has a range of equipment available

Aeroflow Performance says it has a wide variety of Tool and Shop Equipment to deck out your workshop or garage.

Low Profile Car Ramps (AF98-2109 plus mech bag, AF59-2109)
Aeroflow Performance Low Profile Car Ramps are designed to not slide forward when driven onto, they have a lip on the edge so you don’t drive off the ramp, and are very lightweight.
These ramps will bring the car up 65mm off the ground so you can get a jack under the vehicle without causing damage. The ramps also come with a mesh bag to easily transport around in the boot of the vehicle.

Qwik Lift Vehicle Jacks (AF98-2129 plus stand for jacks, AF98-2130)
Aeroflow Performance says its Qwik Lift Vehicle Jacks make it easier to move a car around that isn’t moving under its own power in a small space.
These jacks are sold separately and must be lubricated inside the rollers periodically to maintain the use of them to ensure they can continue to operate.
When using the vehicle jacks, Aeroflow Performance recommends you do not leave a car jacked up on hydraulic pressure – stating you should simply move the vehicle and then get the vehicle off the jacks. Each vehicle jack will support 680kgs (1500lbs).

Workshop Creeper (AF98-2079)
Forget rolling around on the cold, hard, uncomfortable concrete floor with an Aeroflow Performance workshop creeper.
The six swivel castor wheels make it easy to move around underneath a raised and supported vehicle with little effort.
The heavy-duty steel frame holds up to a maximum of 130kg and Aeroflow Performance says the great design of this creeper is the fact that it easily turns into a seat for the ultimate in comfort when working around the workshop.

Fender/Guard Cover (AF99-3010)
Aeroflow Performance fender covers are perfect for mechanics and restorers alike, protecting fenders from scratches, dings, grease and other grunge.
Made from strong PVC foam and reinforced with nylon mesh, the black non-slip material will not harm paint, adheres to slick surfaces, and keeps tools from sliding off. The fender cover measures 558mm x 863mm (34” x 22”) and is completely washable.

For more information, visit